Change home direction - Revision history

Efeldman at 19:50, 6 September 2011

2011-09-06T19:50:30Z

Efeldman at 17:05, 2 September 2011

2011-09-02T17:05:33Z

Efeldman at 17:05, 2 September 2011

2011-09-02T17:05:12Z

Efeldman at 16:58, 2 September 2011

2011-09-02T16:58:37Z

Efeldman: Created page with "The Techno interface specifies which direction the machine travels in when homing. If the home direction is to be changed due to preference or because an axis is traveling in th..."

2011-09-02T16:57:50Z

Created page with "The Techno interface specifies which direction the machine travels in when homing. If the home direction is to be changed due to preference or because an axis is traveling in th..."

New page

The Techno interface specifies which direction the machine travels in when homing.

If the home direction is to be changed due to preference or because an axis is traveling in the wrong direction during home:

* Click Setup
* Click Advanced
* Click Homing Params

You will receive a screen as such:

[[File:Home_direction.jpg]]

The options buttons next to + and - dictate the direction of home.
To change direction, simply choose the button opposite of the one currently selected.

@@ Line 2: / Line 2: @@
 '''CRITICAL NOTE:'''
-'''* After changing the home direction for an axis, any [[Stored Offsets]] and [[Tool Stand Locations]] will need to be re-learned.'''
+'''After changing the home direction for an axis, any [[Stored Offsets]] and [[Set_Tool_Stand_Locations_Tutorial|Tool Stand Locations]] will need to be re-learned.'''
 If the home direction is to be changed due to preference or because an axis is traveling in the wrong direction during home:

@@ Line 2: / Line 2: @@
 '''CRITICAL NOTE:'''
-'''* After changing the home direction for an axis, any [[Stored Offsets]] and [[Tool Stand Location will need to be re-learned.'''
+'''* After changing the home direction for an axis, any [[Stored Offsets]] and [[Tool Stand Locations]] will need to be re-learned.'''
 If the home direction is to be changed due to preference or because an axis is traveling in the wrong direction during home:

← Older revision		Revision as of 17:05, 2 September 2011
Line 1:		Line 1:
	The Techno interface specifies which direction the machine travels in when homing.		The Techno interface specifies which direction the machine travels in when homing.
		+
		+	'''CRITICAL NOTE:'''
		+	'''* After changing the home direction for an axis, any [[Stored Offsets]] and [[Tool Stand Location will need to be re-learned.'''

	If the home direction is to be changed due to preference or because an axis is traveling in the wrong direction during home:		If the home direction is to be changed due to preference or because an axis is traveling in the wrong direction during home:

← Older revision		Revision as of 16:58, 2 September 2011
Line 13:		Line 13:
	The options buttons next to + and - dictate the direction of home.		The options buttons next to + and - dictate the direction of home.
	To change direction, simply choose the button opposite of the one currently selected.		To change direction, simply choose the button opposite of the one currently selected.
		+
		+	Typically, M1 is the Y axis, M2 is X, and M3 is Z.
		+	The motors are labeled from the ground up, M1 being the physically lowest motor.