Jperetzman at 16:27, 4 January 2011

2011-01-04T16:27:14Z

Jperetzman: Created page with "{{ManualNavigation (servo)}} {{WIP}} In order to set up parallel A & Z axes with their respective end effectors (e.g. spindle and drill bank), follow the steps below: * Open ..."

2011-01-04T16:26:32Z

Created page with "{{ManualNavigation (servo)}} {{WIP}} In order to set up parallel A & Z axes with their respective end effectors (e.g. spindle and drill bank), follow the steps below: * Open ..."

New page

{{ManualNavigation (servo)}}

{{WIP}}

In order to set up parallel A & Z axes with their respective end effectors (e.g. spindle and drill bank), follow the steps below:

* Open the interface.
* Go to Setup -> System.
* Enter the correct scale factor for M4.
* Disable the rotary and lathe options.

This will enable the Touch Off A Zero Position in the Toolchanger Operation window.

[[File:Toolchange_operations_windo.gif]]

NOTE: Within Setup -> Advanced -> Software Switches, we can check A Pause Retract Relative. This will retract the A axis every time the system is paused while running a file.

@@ Line 3: / Line 3: @@
 {{WIP}}
-In order to set up parallel A & Z axes with their respective end effectors (e.g. spindle and drill bank), follow the steps below:
+In order to set up parallel Z & A axes with their respective end effectors (e.g. spindle and drill bank), follow the steps below:
 * Open the interface.

Parallel Z & A axes - Revision history

Jperetzman at 16:27, 4 January 2011

Jperetzman: Created page with "{{ManualNavigation (servo)}} {{WIP}} In order to set up parallel A & Z axes with their respective end effectors (e.g. spindle and drill bank), follow the steps below: * Open ..."