Jbeck at 22:51, 21 December 2010

2010-12-21T22:51:54Z

Jperetzman: Created page with "=== Scenario === When running a File, the Progress Bar or the Current Position is not being updated. === Problem === There is a setup issue. The settings in the Techno CNC Inter..."

2010-10-20T14:33:21Z

Created page with "=== Scenario === When running a File, the Progress Bar or the Current Position is not being updated. === Problem === There is a setup issue. The settings in the Techno CNC Inter..."

New page

=== Scenario ===
When running a File, the Progress Bar or the Current Position is not being updated.

=== Problem ===
There is a setup issue. The settings in the Techno CNC Interface need to be adjusted.

=== Solution ===

* Open the Techno CNC Interface.
* Click on '''Setup''' > '''Advanced''' > '''Software Switches'''
* Find the '''"Computer Speed Assist"''' checkbox.
* Set the value that works best for your machine.
** '''''Less than -11''''' updates progress bar and position numbers.
** '''''Between -10 and 0''''', updates the progress bar and the position numbers only when there is a full stop in the move.
** '''''Between 1 and 5''''', updates the progress bar only.
** '''''Greater than 6''''', it does not update anymore.
* Click '''"OK"''' to save change

=== Important Note ===
The different computer speed options exist due to different performance among host computers. If you machine starts jerking or decreases cut quality, this means that the computer is not fast enough to process the cutting job and to update the screen. In this case, make sure to update the range to a less intensive range.

[[Category:Knowledge Base]]

@@ Line 7: / Line 7: @@
 === Solution ===
-* Open the Techno CNC Interface.
+Visit [[Interface Update Frequency]] to set your software appropriately. This setting will allow your software to update the positional and progress display much faster.
-* Click on '''Setup''' > '''Advanced''' > '''Software Switches'''
-* Find the '''"Computer Speed Assist"''' checkbox.
-* Set the value that works best for your machine.
-** '''''Less than -11''''' updates progress bar and position numbers.
-** '''''Between -10 and 0''''', updates the progress bar and the position numbers only when there is a full stop in the move.
-** '''''Between 1 and 5''''', updates the progress bar only.
-** '''''Greater than 6''''', it does not update anymore.
-* Click '''"OK"''' to save change
 === Important Note ===
-The different computer speed options exist due to different performance among host computers. If you machine starts jerking or decreases cut quality, this means that the computer is not fast enough to process the cutting job and to update the screen. In this case, make sure to update the range to a less intensive range.
+The different computer speed options exist due to different performance among host computers. If you machine starts jerking or decreases cut quality, this means that the computer is not fast enough to process the cutting job and to update the screen. In this case, make sure to update the range to a less intensive setting.
 [[Category:Knowledge Base]]

Progress Bar or Current Position is not updated - Revision history

Jbeck at 22:51, 21 December 2010

Jperetzman: Created page with "=== Scenario === When running a File, the Progress Bar or the Current Position is not being updated. === Problem === There is a setup issue. The settings in the Techno CNC Inter..."