Pulses were gained or lost - Revision history

Jglica at 20:58, 2 January 2013

2013-01-02T20:58:22Z

Efeldman at 14:51, 4 September 2012

2012-09-04T14:51:42Z

Efeldman at 17:17, 6 September 2011

2011-09-06T17:17:12Z

Efeldman at 18:00, 2 September 2011

2011-09-02T18:00:30Z

Efeldman: Created page with "One of the following errors are received: File:Axis_lost_pulses.jpg File:Axis_lost_pulses_2.jpg This is a very critical error that can result in a lot of problems: * ..."

2011-09-02T17:56:16Z

Created page with "One of the following errors are received: File:Axis_lost_pulses.jpg File:Axis_lost_pulses_2.jpg This is a very critical error that can result in a lot of problems: * ..."

New page

One of the following errors are received:

[[File:Axis_lost_pulses.jpg]]

[[File:Axis_lost_pulses_2.jpg]]

This is a very critical error that can result in a lot of problems:

* Machine drift
* Runaway conditions
* Location problems
* Cut quality issues

The causes of this problem are (in order of probability):

* Dust on the encoder (if the environment is dusty)
* Broken encoder
* Bent Control Cable pin or damaged cable (LC Plus or Premium electronics only, this is NEVER caused by a bent pin on an LC / LP controller)
* Nicked or damaged encoder cable wire

← Older revision		Revision as of 20:58, 2 January 2013
Line 4:		Line 4:

	[[File:Axis_lost_pulses_2.jpg]]		[[File:Axis_lost_pulses_2.jpg]]
		+
		+	The error code associated with this problem is: 04052010.

	This is a very critical error that can result in a lot of problems:		This is a very critical error that can result in a lot of problems:

← Older revision		Revision as of 14:51, 4 September 2012
Line 17:		Line 17:
	* [[Verify control cable\|Bent Control Cable pin or damaged cable]] (LC Plus or Premium electronics only, this is NEVER caused by a bent pin on an LC / LP controller)		* [[Verify control cable\|Bent Control Cable pin or damaged cable]] (LC Plus or Premium electronics only, this is NEVER caused by a bent pin on an LC / LP controller)
	* Nicked or damaged encoder cable wire		* Nicked or damaged encoder cable wire
		+
		+	Still not sure what is going on here? Read: [[About drift issues]]

@@ Line 14: / Line 14: @@
 The causes of this problem are (in order of probability):
-* [[Encoder damage|Dust on the encoder]] (if the environment is dusty)
+* [[Encoder damage|Broken encoder / Dust on the encoder]] (if the environment is dusty)
-* [[Encoder damage|Broken encoder]]
 * [[Verify control cable|Bent Control Cable pin or damaged cable]] (LC Plus or Premium electronics only, this is NEVER caused by a bent pin on an LC / LP controller)
 * Nicked or damaged encoder cable wire