http://www.docs.technorouters.com/index.php?action=history&feed=atom&title=Soft_limits 2026-07-19T10:12:42Z Revision history for this page on the wiki MediaWiki 1.24.4 http://www.docs.technorouters.com/index.php?title=Soft_limits&diff=1992&oldid=prev 2013-02-12T15:40:09Z

<p>Created page with &quot;&#039;&#039;&#039;Setting up Soft Limits&#039;&#039;&#039; &#039;&#039;&#039;Note: You should have Version 1.423.5 or newer to perform this properly.&#039;&#039;&#039; 1) Home the machine 2) zero all axes 3) carefully jog the machine ...&quot;</p> <p><b>New page</b></p><div>'''Setting up Soft Limits'''<br /> <br /> '''Note: You should have Version 1.423.5 or newer to perform this properly.'''<br /> <br /> 1) Home the machine<br /> <br /> 2) zero all axes<br /> <br /> 3) carefully jog the machine to the opposite ends of travel on all axes. Remove the tool from the spindle and get the Z axis as low as possible.<br /> <br /> 4) Click Setup, then Options<br /> <br /> 5) Check the box marked &quot;use soft limits&quot;<br /> <br /> 6) Click the box &quot;Use current pos&quot;. This will fill in values for M1, M2, M3 and M4 if present. <br /> <br /> 7) Click OK in the lower left.<br /> <br /> Your machine will now stop short of the end of travel just before it hits the switch (unless your axis is set to rotary in setup, system). <br /> <br /> Your system will not jog faster than 200IPM until it has been homed.</div>

Efeldman