Efeldman at 17:50, 6 September 2011

2011-09-06T17:50:33Z

Efeldman: Created page with "=== Scenario === You receive a message that an axis is at the "End of Travel" even though it is not. The axis moves very slowly when jogging, regardless of the speed it is set ..."

2011-09-01T21:44:04Z

Created page with "=== Scenario === You receive a message that an axis is at the "End of Travel" even though it is not. The axis moves very slowly when jogging, regardless of the speed it is set ..."

New page

=== Scenario ===

You receive a message that an axis is at the "End of Travel" even though it is not.
The axis moves very slowly when jogging, regardless of the speed it is set to move.

=== Problem ===

A Limit switch is damaged, disconnected or not present.

=== Solution ===

Checking the limit switch procedure to be completed later. --ESF

← Older revision		Revision as of 17:50, 6 September 2011
Line 10:		Line 10:
	=== Solution ===		=== Solution ===

−	~~Checking~~ the limit switch ~~procedure~~ to ~~be completed later~~. ~~--ESF~~	+	The limit switch must be checked.
		+
		+	Find the limit switch connector for the motor of the axis that is causing the error.
		+
		+	[[File:Home_switch_connector.psd.jpg]]
		+
		+	Check that the connector is good and completely engaged.
		+
		+	If the problem persists, we must narrow down the location of the problem:
		+
		+	Note: Home switches are normally closed, so closing the circuit makes the machine think the system is not on the switch.
		+
		+	* Click Setup
		+	* Click Diagnostics
		+	* Locate the home indicator readout for the axis that is causing trouble under HOME in the lower left.
		+	* Short the 2 pins on the connector that is attached to the motor (not the one that goes to the axis)
		+	*If it does not light up, check the [[Verify control cable\|controller cable]] and check the rectangular motor cable. The problem is not with the axis wiring or limit switch
		+
		+	* If the home box in diagnostics lights up, the wiring from the motor to the control board is good.
		+	* Obtain a multimeter
		+	* [[Multimeter\|Set the multimeter to continuity]] or ohms.
		+	* Test the continuity between the two pins of the cable that goes into the axis (not the motor).
		+
		+	* If there is no continuity, either the wire is broken or the [[Switch is smashed]].
		+
		+	* If there is continuity, there is likely no engagement between the connectors. Inspect the connectors for loose or broken wires.

Very slow jogging - Revision history

Efeldman at 17:50, 6 September 2011

Efeldman: Created page with "=== Scenario === You receive a message that an axis is at the "End of Travel" even though it is not. The axis moves very slowly when jogging, regardless of the speed it is set ..."