Very slow motion - Revision history

Efeldman: /* Problem */

2011-09-01T21:31:09Z

‎Problem

Jbeck at 16:32, 1 October 2010

2010-10-01T16:32:55Z

Jbeck at 16:32, 1 October 2010

2010-10-01T16:32:40Z

Jbeck: Created page with "== Router jogs normally, but moves slow when running a file == === Scenario === * when running a file, the machine moves very slow although it jogs normally === Problem === Th..."

2010-10-01T16:31:37Z

Created page with "== Router jogs normally, but moves slow when running a file == === Scenario === * when running a file, the machine moves very slow although it jogs normally === Problem === Th..."

New page

== Router jogs normally, but moves slow when running a file ==

=== Scenario ===
* when running a file, the machine moves very slow although it jogs normally

=== Problem ===

The NC file may contain no feedrates (Fxxx in [[G-code]]) and so it reverts to the Override speed. Or if feedrates are specified correctly, the software may be set up to override your feedrates.

=== Solution ====

In the Techno CNC Interface (Setup > Speed), the Feedrate might be set to "Override", and so it moves at the speed indicated in the Interface and not at the speed programmed in the NC file. Simply set the Feedrate to Auto and it will use the speeds specified in the file.

Be sure that you have F g-code commands in your file, and that the speeds are appropriate.

← Older revision		Revision as of 16:32, 1 October 2010
Line 14:		Line 14:

	Be sure that you have F g-code commands in your file, and that the speeds are appropriate.		Be sure that you have F g-code commands in your file, and that the speeds are appropriate.
		+
		+
		+	[[Category:Knowledge Base]]

@@ Line 7: / Line 7: @@
 === Problem ===
-The NC file may contain no feedrates (Fxxx in [[G-code]]) and so it reverts to the Override speed. Or if feedrates are specified correctly, the software may be set up to override your feedrates.
+*The NC file may contain no feedrates (missing any Fxxx in [[G-code]]) and so it reverts to the Default speed of 100 units per minute.
 === Solution ===

@@ Line 1: / Line 1: @@
-== Router jogs normally, but moves slow when running a file ==
+== Slow motion when running a g-code file ==
 === Scenario ===
-* when running a file, the machine moves very slow although it jogs normally
 === Problem ===
@@ Line 8: / Line 9: @@
 The NC file may contain no feedrates (Fxxx in [[G-code]]) and so it reverts to the Override speed. Or if feedrates are specified correctly, the software may be set up to override your feedrates.
-=== Solution ====
+=== Solution ===
 In the Techno CNC Interface (Setup > Speed), the Feedrate might be set to "Override", and so it moves at the speed indicated in the Interface and not at the speed programmed in the NC file. Simply set the Feedrate to Auto and it will use the speeds specified in the file.
 Be sure that you have F g-code commands in your file, and that the speeds are appropriate.