From TechnoDocs
(→Scenario) |
(→Solution) |
||
| Line 7: | Line 7: | ||
=== Solution === | === Solution === | ||
At this time, the only solution is to provide the router with a 32-bit Windows PC, either by switching PC's or re-formatting the current PC with 32-bit Windows. | At this time, the only solution is to provide the router with a 32-bit Windows PC, either by switching PC's or re-formatting the current PC with 32-bit Windows. | ||
| − | (PC's with a 64-bit processor can run 32-bit Windows. What this means is that it's fine if the PC has 64-bit hardware, but you must install 32-bit Windows on it) | + | :(PC's with a 64-bit processor can run 32-bit Windows. What this means is that it's fine if the PC has 64-bit hardware, but you must install 32-bit Windows on it) |
[[Category:Knowledge Base]] | [[Category:Knowledge Base]] | ||
Revision as of 13:21, 13 October 2010
Scenario
After upgrading the PC used for the machine, nothing seems to work, and although the Techno CNC Interface opens, it does so with errors.
Problem
This is a software/driver issue. The drivers for the PCI controller card require 32-bit Windows® because they will not function in a 64-bit environment.
Solution
At this time, the only solution is to provide the router with a 32-bit Windows PC, either by switching PC's or re-formatting the current PC with 32-bit Windows.
- (PC's with a 64-bit processor can run 32-bit Windows. What this means is that it's fine if the PC has 64-bit hardware, but you must install 32-bit Windows on it)