From TechnoDocs
(Created page with "=== Scenario === You are repeatedly getting an error that looks like this: Image:Error_communicating.jpg The error says the system cannot communicate with an axis or the s...") |
|||
| Line 26: | Line 26: | ||
This error with the LC Plus / MP controller / Premium Controller means one of the following situations is in play: | This error with the LC Plus / MP controller / Premium Controller means one of the following situations is in play: | ||
| − | *The drivers are not installed [[ | + | *The drivers are not installed [[Driver problems]] |
*The PCI card is not installed or is damaged. Try reseating the PCI card in another PCI slot if possible. | *The PCI card is not installed or is damaged. Try reseating the PCI card in another PCI slot if possible. | ||
[[Category:Knowledge Base]] | [[Category:Knowledge Base]] | ||
Revision as of 14:23, 1 September 2011
Scenario
You are repeatedly getting an error that looks like this:
The error says the system cannot communicate with an axis or the servo controller.
Problem
The computer is unable to communicate with the controller.
Solution
First, identify which Controller box you are using.
LC / LP Control box:
This error with the LC / LP controller means one of the following situations is in play:
- The control box is not powered on or plugged in Verify power
- The cable between the computer is damaged or not plugged in Verify control cable
LC Plus / MP controller / Premium Controller
This error with the LC Plus / MP controller / Premium Controller means one of the following situations is in play:
- The drivers are not installed Driver problems
- The PCI card is not installed or is damaged. Try reseating the PCI card in another PCI slot if possible.