Difference between revisions of "Machine will not work after PC upgrade"

Latest revision as of 14:51, 1 September 2011

After upgrading the PC used for the machine, nothing seems to work.

The Techno CNC Interface might open, but it does so with errors.

This is a likely software/driver issue.

Check the main troubleshooting page for the error that most closely resembles the error you are receiving when starting the cnc interface.

@@ Line 1: / Line 1: @@
 === Scenario ===
-After upgrading the PC used for the machine, nothing seems to work, and although the Techno CNC Interface opens, it does so with multiple errors.
+After upgrading the PC used for the machine, nothing seems to work.
+The Techno CNC Interface might open, but it does so with errors.
 === Problem ===
-This is a software/driver issue. The drivers for the PCI controller card require 32-bit Windows® because they will not function in a 64-bit environment.
+This is a likely software/driver issue.
 === Solution ===
-At this time, the only solution is to provide the router with a 32-bit Windows PC, either by switching PC's or re-formatting the current PC with 32-bit Windows.
-(PC's with a 64-bit processor can run 32-bit Windows, though PC's with 32-bit processor cannot run 64-bit Windows. This means it's OK to have 64-bit hardware, but you must install 32-bit Windows on it)
+Check the main [[troubleshooting]] page for the error that most closely resembles the error you are receiving when starting the cnc interface.
 [[Category:Knowledge Base]]