From TechnoDocs
(Created page with "One of the following errors are received: File:Axis_lost_pulses.jpg File:Axis_lost_pulses_2.jpg This is a very critical error that can result in a lot of problems: * ...") |
(No difference)
|
Revision as of 10:56, 2 September 2011
One of the following errors are received:
This is a very critical error that can result in a lot of problems:
- Machine drift
- Runaway conditions
- Location problems
- Cut quality issues
The causes of this problem are (in order of probability):
- Dust on the encoder (if the environment is dusty)
- Broken encoder
- Bent Control Cable pin or damaged cable (LC Plus or Premium electronics only, this is NEVER caused by a bent pin on an LC / LP controller)
- Nicked or damaged encoder cable wire