From TechnoDocs
(Created page with "If the machine is cutting parallelograms where rectangles or squares were desired, the problem may be machine squareness. This error is typically consistent and has a magnitude...") |
|||
| Line 5: | Line 5: | ||
Download the following document on squaring the machine and follow the steps within. | Download the following document on squaring the machine and follow the steps within. | ||
| − | [[ | + | [[0326_Reindicate_LC_Series.pdf]] |
Revision as of 11:12, 2 September 2011
If the machine is cutting parallelograms where rectangles or squares were desired, the problem may be machine squareness.
This error is typically consistent and has a magnitude of 0.005" to 0.100".
Download the following document on squaring the machine and follow the steps within.