From TechnoDocs
(Created page with "=== Scenario === The machine is cutting too far into a part or not far enough. This is an issue from the start of the file and stays at a consistent depth through the run (it d...") |
(No difference)
|
Revision as of 10:37, 6 September 2011
Scenario
The machine is cutting too far into a part or not far enough.
This is an issue from the start of the file and stays at a consistent depth through the run (it doesn't increase or decrease in depth over time, which is a different problem)
Solution
This is typically one of the following possibilities:
The origin of the part is not set properly.
The Scale factors are not correct