From TechnoDocs
(Created page with "The Techno CNC interface can run on most modern computers. The current PC '''requirements''' are * Pentium 3 400mHz * 128 MB ram * Full Size PCI slot The current '''suggested...") |
(Moved the information to the other page (this was a duplicate, with not-up-to-date information)) |
||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | + | See [[Computer requirements]]. | |
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||
| − | + | ||