|
|
| (One intermediate revision by the same user not shown) |
| Line 1: |
Line 1: |
| − | The Techno CNC interface can run on most modern computers.
| + | See [[Computer requirements]]. |
| − | | + | |
| − | The current PC '''requirements''' are
| + | |
| − | * Pentium 3 400mHz
| + | |
| − | * 128 MB ram
| + | |
| − | * Full Size PCI slot
| + | |
| − | | + | |
| − | The current '''suggested''' PC specifications are:
| + | |
| − | * Dual core Pentium processor
| + | |
| − | * 2gb ram
| + | |
| − | * Full size PCI slot
| + | |
| − | * Internet connection (for remote troubleshooting)
| + | |
| − | | + | |
| − | Note that if you wish to have a network connected to the PC while running files, you must have a dual core or quad core processor.
| + | |
| − | | + | |
| − | The Techno CNC Interface works with the following Operating systems
| + | |
| − | | + | |
| − | * Windows 98SE
| + | |
| − | * Windows 2000
| + | |
| − | * Windows XP 32 and 64 bit editions
| + | |
| − | * Windows Vista 32 and 64 bit editions
| + | |
| − | * Windows 7 32 and 64 bit editions
| + | |
| − | | + | |
| − | Some older machines will be running DOS software. These machines are also using an ISA version of the Techno CNC controller. Upgrading these machines to Windows Operating systems will require a new PCI card which will work with the old [[Controller box]]
| + | |
Latest revision as of 10:00, 1 March 2012
See Computer requirements.