From TechnoDocs
(Created page with "'''Marking pulleys''' Marking pulleys is used to determine whether or not the pulleys are slipping on the motor or ball screw shafts. Drifting pulleys can be responsible for ma...") |
m |
||
| Line 2: | Line 2: | ||
| − | Marking pulleys is used to determine whether or not the pulleys are slipping on the motor or ball screw shafts. Drifting pulleys can be responsible for machine drift. | + | Marking pulleys is used to determine whether or not the pulleys are slipping on the motor or ball screw shafts. Drifting pulleys can be responsible for [[Drift_test|machine drift]]. |
Step 1: Mark the pulleys in one of two ways: | Step 1: Mark the pulleys in one of two ways: | ||
Revision as of 12:16, 23 April 2012
Marking pulleys
Marking pulleys is used to determine whether or not the pulleys are slipping on the motor or ball screw shafts. Drifting pulleys can be responsible for machine drift.
Step 1: Mark the pulleys in one of two ways:
Step 2: Run the file or perform the operation that would cause the drift issue.
Step 3: Check the pulleys. If the lines no longer line up, the pulley has slipped. Remove, inspect, replace if necessary, and reassemble properly to prevent this from happening again.