From TechnoDocs
(→Scenario) |
|||
| Line 2: | Line 2: | ||
=== Scenario === | === Scenario === | ||
| − | When jogging, the machine moves the wrong distance with repeatabilty, | + | When jogging, the machine moves the wrong distance with repeatabilty, i.e. the NC file calls for a 5" cut, but the machine cuts 7" ''every time'' |
=== Problem === | === Problem === | ||
Revision as of 13:34, 13 October 2010
When the router jogs the wrong distance, the cause can be an incorrect Scale factor(s).
Scenario
When jogging, the machine moves the wrong distance with repeatabilty, i.e. the NC file calls for a 5" cut, but the machine cuts 7" every time
Problem
There is a setup issue. The scale factor settings in the Techno CNC Interface need to be adjusted.
Solution
- Click on Setup > System
- Find the "Mx Scale" section.
- Change the Scale Factor(s) to the correct value(s) for the machine (see the Scale Factor label on the gantry or call Techno Technical Support).
- Click "OK" to save change