From TechnoDocs
(→Replacement) |
(→Replacement) |
||
| Line 20: | Line 20: | ||
'''Spindle Part Numbers''' | '''Spindle Part Numbers''' | ||
| − | * | + | *'''H24G53-MT1073-3''' 3HP HSD Router Set (6000 -18000 RPM) |
| + | :220V, 3-phase or single phase | ||
| + | :Mounting bracket, vacuum shroud | ||
| + | :Collet wrenches, 1/8", 3/16", 1/4", 5/16", 3/8", | ||
| + | :1/2" collets, and collet nut. | ||
| − | * | + | |
| + | |||
| + | *'''H24G53-MT1073-5''' 5HP HSD Router Set (6000 to 18000 RPM) | ||
| + | :220V, 3-phase or single phase | ||
| + | :Mounting bracket, vacuum shroud | ||
| + | :Collet wrenches, 1/8", 3/16", 1/4", 5/16", 3/8", | ||
| + | :1/2" collets, and collet nut. | ||
| + | |||
| + | |||
| + | . | ||
== Troubleshooting & Maintenance for Colombo Spindles == | == Troubleshooting & Maintenance for Colombo Spindles == | ||
Revision as of 07:45, 20 October 2010
Spindles are the business end of the router. They provide the rotational torque that does the work of cutting.
Major brands
Colombo, HSD, Kress, and Porter-Cable. We use primarily Colombo and HSD spindles. Kress and Porter-Cable spindles are basically just souped-up Dremels.
Replacement
Important factors for replacing a spindle are: HP, Voltage, Amperage, and RPMs found on the nameplate (see fig 2). As there may be multiple specs on a nameplate, a PICTURE is usually the best way to determine the right motor.
Spindle Part Numbers
- H24G53-MT1073-3 3HP HSD Router Set (6000 -18000 RPM)
- 220V, 3-phase or single phase
- Mounting bracket, vacuum shroud
- Collet wrenches, 1/8", 3/16", 1/4", 5/16", 3/8",
- 1/2" collets, and collet nut.
- H24G53-MT1073-5 5HP HSD Router Set (6000 to 18000 RPM)
- 220V, 3-phase or single phase
- Mounting bracket, vacuum shroud
- Collet wrenches, 1/8", 3/16", 1/4", 5/16", 3/8",
- 1/2" collets, and collet nut.
.
Troubleshooting & Maintenance for Colombo Spindles
