From TechnoDocs
(Created page with "=== Scenario === The machine is cutting too far into a part or not far enough. This is an issue from the start of the file and stays at a consistent depth through the run (it d...") |
|||
| Line 9: | Line 9: | ||
This is typically one of the following possibilities: | This is typically one of the following possibilities: | ||
| − | The [[ | + | The [[Set the origin|origin of the part]] is not set properly. |
The [[Scale factors]] are not correct | The [[Scale factors]] are not correct | ||
Latest revision as of 10:38, 6 September 2011
Scenario
The machine is cutting too far into a part or not far enough.
This is an issue from the start of the file and stays at a consistent depth through the run (it doesn't increase or decrease in depth over time, which is a different problem)
Solution
This is typically one of the following possibilities:
The origin of the part is not set properly.
The Scale factors are not correct