All Axes are frozen

All axes are frozen (i.e. will not move for some reason.)

All Axes will not move via interface or when running an NC file.
Receives multiple "M-x Position error, no power to controller. Re-enable controller?", circular error

1) It is possible the router's controller is simply not powered up.

2) The SCSI cable, for some reason, is not making the required connection between the PC to the controller.

3) The Computer card is either not functioning or not properly installed

4) The controller's Mainboard is not functioning.

1) Turn the router's Controller "ON", and verify that the controller's LED lights are ALL "Lit" and the controller is "ON"

2) Clean and re-seat the SCSI connector, starting with the end connecting to the PC. Test the cable for continuity with a multimeter.

3) Check Device Manager and verify PCI card is working. If not, reinstall driver and/or re-seat the card in the PCI slot.

4) If you suspect the controller mainboard is not functioning properly, contact Techno's free Technical Support department.

Navigation menu