From TechnoDocs
Revision as of 09:50, 2 September 2011 by Efeldman (Talk | contribs) (Created page with "The Techno CNC interface can run on most modern computers. The current PC '''requirements''' are * Pentium 3 400mHz * 128 MB ram * Full Size PCI slot The current '''suggested...")
The Techno CNC interface can run on most modern computers.
The current PC requirements are
- Pentium 3 400mHz
- 128 MB ram
- Full Size PCI slot
The current suggested PC specifications are:
- Dual core Pentium processor
- 2gb ram
- Full size PCI slot
Note that if you wish to have a network connected to the PC while running files, you must have a dual core or quad core processor.
The Techno CNC Interface works with the following Operating systems
Windows 98SE Windows 2000 Windows XP 32 and 64 bit editions Windows Vista 32 and 64 bit editions Windows 7 32 and 64 bit editions
Some older machines will be running DOS software. These machines are also using an ISA version of the Techno CNC controller. Upgrading these machines to Windows Operating systems will require a new PCI card which will work with the old Controller box