From TechnoDocs
Line 1: | Line 1: | ||
− | When the router jogs in the wrong direction, the cause is most often an incorrect sign in the Scale | + | When the router jogs in the wrong direction, the cause is most often an incorrect sign in the [[Scale factors]]. |
=== Scenario === | === Scenario === |
Revision as of 13:09, 15 December 2010
When the router jogs in the wrong direction, the cause is most often an incorrect sign in the Scale factors.
Scenario
When jogging, the machine moves in the wrong direction.
Problem
There is a setup issue. The scale factor settings in the Techno CNC Interface need to be adjusted.
Solution
- Click on Setup > System
- Find the "Mx Scale" section.
- Change the sign of the axis affected. If it has a 'minus' sign, remove it. If it has no sign, add a '-' before the number.
- Click "OK" to save change