From TechnoDocs
(Created page with "When the router jogs in the wrong direction, the cause is most often caused by an incorrect sign in the scale factors. === Scenario === When jogging, the machine moves in the wr...") |
|||
| Line 13: | Line 13: | ||
* Change the sign of the axis affected. If it has a 'minus' sign, remove it. If it has no sign, add a '-' before the number. | * Change the sign of the axis affected. If it has a 'minus' sign, remove it. If it has no sign, add a '-' before the number. | ||
* Click "OK" to save change | * Click "OK" to save change | ||
| + | |||
| + | [[Category:Knowledge Base]] | ||
Revision as of 09:25, 1 October 2010
When the router jogs in the wrong direction, the cause is most often caused by an incorrect sign in the scale factors.
Scenario
When jogging, the machine moves in the wrong direction.
Problem
There is a setup issue. The scale factor settings in the Techno CNC Interface need to be adjusted.
Solution
- Click on Setup > System
- Find the "Mx Scale" section.
- Change the sign of the axis affected. If it has a 'minus' sign, remove it. If it has no sign, add a '-' before the number.
- Click "OK" to save change