From TechnoDocs
Jperetzman (Talk | contribs) (Created page with "=== Scenario === When running a File, the Progress Bar or the Current Position is not being updated. === Problem === There is a setup issue. The settings in the Techno CNC Inter...") |
|||
Line 7: | Line 7: | ||
=== Solution === | === Solution === | ||
− | + | Visit [[Interface Update Frequency]] to set your software appropriately. This setting will allow your software to update the positional and progress display much faster. | |
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
− | + | ||
=== Important Note === | === Important Note === | ||
− | The different computer speed options exist due to different performance among host computers. If you machine starts jerking or decreases cut quality, this means that the computer is not fast enough to process the cutting job and to update the screen. In this case, make sure to update the range to a less intensive | + | The different computer speed options exist due to different performance among host computers. If you machine starts jerking or decreases cut quality, this means that the computer is not fast enough to process the cutting job and to update the screen. In this case, make sure to update the range to a less intensive setting. |
[[Category:Knowledge Base]] | [[Category:Knowledge Base]] |
Latest revision as of 15:51, 21 December 2010
Contents
Scenario
When running a File, the Progress Bar or the Current Position is not being updated.
Problem
There is a setup issue. The settings in the Techno CNC Interface need to be adjusted.
Solution
Visit Interface Update Frequency to set your software appropriately. This setting will allow your software to update the positional and progress display much faster.
Important Note
The different computer speed options exist due to different performance among host computers. If you machine starts jerking or decreases cut quality, this means that the computer is not fast enough to process the cutting job and to update the screen. In this case, make sure to update the range to a less intensive setting.