From TechnoDocs
Revision as of 07:33, 20 October 2010 by Jperetzman (Talk | contribs) (Created page with "=== Scenario === When running a File, the Progress Bar or the Current Position is not being updated. === Problem === There is a setup issue. The settings in the Techno CNC Inter...")
Contents
Scenario
When running a File, the Progress Bar or the Current Position is not being updated.
Problem
There is a setup issue. The settings in the Techno CNC Interface need to be adjusted.
Solution
- Open the Techno CNC Interface.
- Click on Setup > Advanced > Software Switches
- Find the "Computer Speed Assist" checkbox.
- Set the value that works best for your machine.
- Less than -11 updates progress bar and position numbers.
- Between -10 and 0, updates the progress bar and the position numbers only when there is a full stop in the move.
- Between 1 and 5, updates the progress bar only.
- Greater than 6, it does not update anymore.
- Click "OK" to save change
Important Note
The different computer speed options exist due to different performance among host computers. If you machine starts jerking or decreases cut quality, this means that the computer is not fast enough to process the cutting job and to update the screen. In this case, make sure to update the range to a less intensive range.