From TechnoDocs
Jump to: navigation, search
(Created page with "{{Control Software (lathe)|Techno Lathe Manual}} {{WIP}} This feature allows us to display the lathe or rotary buttons. In order to achieve this, we need to: * Go into ''Setu...")
 
Line 1: Line 1:
{{Control Software (lathe)|Techno Lathe Manual}}
+
{{Software Manual (lathe)}}
  
 
{{WIP}}
 
{{WIP}}
Line 15: Line 15:
 
* Clicking on the ''lathe'' or ''rotary mode''.
 
* Clicking on the ''lathe'' or ''rotary mode''.
  
 
+
[[Category:Software Manual (lathe)]]
[[Category:Control Software (lathe)]]
+

Revision as of 10:39, 5 May 2011

Template:Software Manual (lathe)

Note!
This article is a work in progress. Check back later, or call us to speed things along.

This feature allows us to display the lathe or rotary buttons.

In order to achieve this, we need to:

  • Go into Setup->system.
  • Enable checkbox Lathe Option.

Once the Lathe option is enabled, we can toggle the buttons by:

  • Right clicking on the 4th axis buttons.
  • Clicking on the lathe or rotary mode.