From TechnoDocs
(→Solution) |
(→Solution) |
||
Line 9: | Line 9: | ||
Disconnect, clean, and reconnect touchpad connectors. | Disconnect, clean, and reconnect touchpad connectors. | ||
− | Note that version 1.421 of the [[Control Software (servo)|control software]] will warn you if this behavior is detected. | + | Note that version 1.421 (and up) of the [[Control Software (servo)|control software]] will warn you if this behavior is detected. |
[[Category:Knowledge Base]] | [[Category:Knowledge Base]] |
Revision as of 13:32, 13 October 2010
Scenario
When moving to touch-off, the tool moves in the wrong direction (away from the touchpad), and it moves very slowly.
Problem
There is a connection issue. The software thinks the touchpad is already contacting the tool, but the sensor or cable connection is just damaged.
Solution
Disconnect, clean, and reconnect touchpad connectors.
Note that version 1.421 (and up) of the control software will warn you if this behavior is detected.