Difference between revisions of "Touch-off problem"

Revision as of 09:43, 1 October 2010

When moving to touch-off, the tool moves in the wrong direction (away from the touchpad), and it moves very slowly.

There is a connection issue. The software thinks the touchpad is already contacting the tool, but the sensor or cable connection is just damaged.

Disconnect, clean, and reconnect touchpad connectors.

Note that version 1.421 of the Control software will warn you if this behavior is detected.

Revision as of 09:43, 1 October 2010 (view source) Jbeck (Talk \| contribs) (Created page with "Scenario: When moving to touch-off, the tool moves in the wrong direction (away from the touchpad), and it moves very slowly. === Problem === There is a connection issue. The so...")		Revision as of 09:43, 1 October 2010 (view source) Jbeck (Talk \| contribs) Newer edit →
Line 1:		Line 1:
−	Scenario:	+	=== Scenario ===
	When moving to touch-off, the tool moves in the wrong direction (away from the touchpad), and it moves very slowly.		When moving to touch-off, the tool moves in the wrong direction (away from the touchpad), and it moves very slowly.