From TechnoDocs
Jperetzman (Talk | contribs) |
Jperetzman (Talk | contribs) |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 4: | Line 4: | ||
== Setup == | == Setup == | ||
| − | # [[ | + | # [[Measuring the offset between the knife and the spindle |Measure knife offset.]] |
[[Category:Software]] | [[Category:Software]] | ||
| − | |||
Latest revision as of 09:50, 13 March 2012
This manual will guide you through the set up and operation of your I-Cut/Techno integration system.