From TechnoDocs
Jperetzman (Talk | contribs) (Created page with "{{ManualNavigation (servo)}} {{WIP}} In order to set up parallel A & Z axes with their respective end effectors (e.g. spindle and drill bank), follow the steps below: * Open ...") |
(No difference)
|
Revision as of 09:26, 4 January 2011
| Control Software Manual for Servo Systems |
| All Software Manuals | Table of Contents (servo) |
|
In order to set up parallel A & Z axes with their respective end effectors (e.g. spindle and drill bank), follow the steps below:
- Open the interface.
- Go to Setup -> System.
- Enter the correct scale factor for M4.
- Disable the rotary and lathe options.
This will enable the Touch Off A Zero Position in the Toolchanger Operation window.
NOTE: Within Setup -> Advanced -> Software Switches, we can check A Pause Retract Relative. This will retract the A axis every time the system is paused while running a file.