Plasma Posts for CAM
Use a standard Post processor for CAM software. The techno software interprets standard techno gcode.
Consumable replacement
Replace all consumables at once, make sure the new ones are a matched set, rated for the amperage they will be run at, and installed as per the manufacturer's instructions.
Work lead
Be sure the work lead is attached to the part to cut and not only to the table.
Air Requirements
The air pressure set at the torch must be set properly (consult the proper pressure for the material being cut in the manual
The air flow must be at least as high as the torch minimum (consult the manual, it is typically at least 6cfm. Techno has a flow meter that can be borrowed to test if necessary)
The air must be clean and dry! Employ air filters and water separators/dryers. Keep in mind that some dryers restrict flow too much and could result in too low of a flow.