From TechnoDocs
| Line 20: | Line 20: | ||
*[[Ensure feedback in setup]] | *[[Ensure feedback in setup]] | ||
*Are you attempting to move the system at a speed higher than possible for the [[Controller box]]? | *Are you attempting to move the system at a speed higher than possible for the [[Controller box]]? | ||
| − | *Is the machine smashing into the [[End of travel]]? | + | *Is the machine smashing into the [[Set the origin|End of travel]]? |
*Is there a blockage in the axis that is causing a [[Frozen axis]]? | *Is there a blockage in the axis that is causing a [[Frozen axis]]? | ||
*Check for [[Amplifier status]]. | *Check for [[Amplifier status]]. | ||
[[Category:Knowledge Base]] | [[Category:Knowledge Base]] | ||
Revision as of 10:40, 6 September 2011
Scenario
You are repeatedly getting the following message box:
Problem
The machine is unable to travel to the position that has been requested of it.
Solution
There are a few pieces of information necessary to determine the cause of this issue.
- Does the machine move properly in any of the axes?
If the machine does not move in any of the axes, you should Verify power to the machine
- Does the machine Run away before getting the position error?
- Verify power to the machine
- Ensure feedback in setup
- Are you attempting to move the system at a speed higher than possible for the Controller box?
- Is the machine smashing into the End of travel?
- Is there a blockage in the axis that is causing a Frozen axis?
- Check for Amplifier status.